Tuesday, October 7, 2014

Halloween Treat - Sucker Holder

Lisa Lara here today.  
Here's a fun little sucker holder you can make as a special Halloween treat for your trick or treaters or parties or to put in the lunch of someone special. 
 I used {die}verse Halloween Tags and Sam E. Snowman.
 Here's a close up, isn't he so cute!
Start with a 2 1/2 x 6 piece and score at 2 1/2 and 3 1/2 along the 6" side
Fold after scoring
Emboss using circle from Sam E. Snowman Die.  I used washi tape to hold die in place and with cutting side up I then put the rubber mat, four pieces of cardstock and two B plates and ran through my Cuttlebug to emboss. 
Here is what it will look like.  Look at the beautiful impression. 
Next I used the same circle again to cut my pumpkin and stamp his face using the {die}verse Halloween Tags Set
Now cut out the tag using {die}verse Halloween Tags Set
I stamped this sentiment also from the same set
I am now embossing the pumpkin using Cuttlebug Distressed Stripes Embossing Folder
Now gather all your supplies to assemble
I put dimensional tape behind the pumpkin and the tag
I then used my crop-a-dile to punch two 1/8" holes that go through the front, sucker plastic and back then thread twine through, attach tag and tie little bow. 
Voila!
die-verse Halloween Tags stamp and die set
{die}verse Halloween Tags Stamp and Die Set

Sam E. Snowman die
Sam E. Snowman Die Set

Lisa Lara

Follow A Jillian Vance Design here:

4 comments:

Shelly said...

How cute is this?!!...Love it!

Annette Allen said...

Lisa is amazing.. i totally love this.. thanks for sharing.

~amy~ said...

Yay for Lisa! Love this treat holder, super FUN!

Rosemary said...

super cute little treat wrap, lisa!