Halloween Treat - Sucker Holder

Lisa Lara here today.  

Here's a fun little sucker holder you can make as a special Halloween treat for your trick or treaters or parties or to put in the lunch of someone special. 

 I used {die}verse Halloween Tags and Sam E. Snowman.

 Here's a close up, isn't he so cute!

Start with a 2 1/2 x 6 piece and score at 2 1/2 and 3 1/2 along the 6" side

Fold after scoring

Emboss using circle from Sam E. Snowman Die.  I used washi tape to hold die in place and with cutting side up I then put the rubber mat, four pieces of cardstock and two B plates and ran through my Cuttlebug to emboss. 

Here is what it will look like.  Look at the beautiful impression. 

Next I used the same circle again to cut my pumpkin and stamp his face using the {die}verse Halloween Tags Set

Now cut out the tag using {die}verse Halloween Tags Set

I stamped this sentiment also from the same set

I am now embossing the pumpkin using Cuttlebug Distressed Stripes Embossing Folder

Now gather all your supplies to assemble

I put dimensional tape behind the pumpkin and the tag

I then used my crop-a-dile to punch two 1/8" holes that go through the front, sucker plastic and back then thread twine through, attach tag and tie little bow. 

Voila!

{die}verse Halloween Tags Stamp and Die Set

Sam E. Snowman Die Set

Lisa Lara

Follow A Jillian Vance Design here: